Primera Technology RX900 - Manual (Page 64)

60 Notices and Warnings
Section 8: Notices and Warnings
Notices: The information in this document is subject to change without notice.
NO WARRANTY OF ANY KIND IS MADE WITH REGARD TO THIS MATERI-
AL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. No lia-
bility is assumed for errors contained herein or for incidental or consequential
damages in connection with the furnishing, performance, or use of this materi-
al. This document contains proprietary information that is protected by copy-
right. All rights are reserved. No part of this document may be photocopied,
reproduced, or translated into another language without prior written consent.
Trademark Acknowledgments: Windows is a registered trademark of Microsoft
Corporation. All other trademarks are the property of their respective owners.
Printing History
Edition 1.0, #021711, Copyright 2011, All rights reserved.
FCC Compliance Statement: This device complies with part 15 of the FCC
rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
For Users in the United States: This product is intended to be supplied by a UL
listed Direct Plug-In Power Supply marked "Class 2"or a UL listed ITE Power
Supply marked "LPS" with output rated 12VDC, 4.5A or higher. This equipment
has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. In a domestic environment this product
may cause radio interference, in which case the user may be required to take
adequate measures. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cables is required to comply with the Class B limits of Part 15 of
the FCC Rules. You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority to operate and/or
obtain warranty service for this equipment.
RX900.qxd 2/17/2011 1:33 PM Page 60
TOC INDEX