Primera Technology RX900 - Manual (Page 23)

Using RFID 19
If write failures continue even after adjusting the position
of the writer, try adjusting the Antenna Power. First select
Stop Test. Now increase or decrease the power using the
up and down arrows. Click Set to send the setting to the
printer. Try a Writing Test again. After a successful Writing
test you may choose to verify the writing by running a
reading test on the same label/tag.
B. PRINTING AND ENCODING
Once you have a successful write test, you are ready to print
from your RFID equipped software program!
Refer to the print-
ing application’s
documentation for
details on RFID
printing. A trial
version of
Bartender is
included on the
installation disc.
To add RFID
encoding to a label design using Bartender, once the label size
has been chosen and the blank label is on screen, click the
Standard RFID button on the lower left to display all RFID
options. Simply drag the desired data format to the area
around the label. Double click on the icon that appears to set
the data or data source.
Note on Encoding Errors: During printing from any application if an
encoding error appears, the PTStatus monitor will appear and dis-
play an error. It will try to encode again after making calibration
adjustments. If it fails to encode, by default a series of XXXXs will
automatically be printed on the label to indicate that it was not
encoded properly. The job will then continue.
RX900.qxd 2/17/2011 1:28 PM Page 19
TOC INDEX