Pitney Bowes ADDRESSRIGHT DA400 - Manual (Page 30)

3-5
Basics
4. Setting the Wireframe Ramp
A. Make sure the ramp is at the top of the Wireframe.
B. Place a piece of material
onto the Wireframe as
shown and adjust the
ramp downwards until
the material is resting
half way down the angle
of the ramp surface.
NOTE: The Sliding
Fence is not shown for
ease of illustration.
C. Tighten the ramp securing knob.
Setting
Up A Job
(continued)
5. Positioning the Feed Fence
A. Place a sample piece or
trial stack of material in
the input area.
B. Slide the fence until
it almost touches the
stack of material. Check
that there's about 1/16
inch (1.5mm) clearance
between the fence and
the stack.
NOTE: Proper clearance is important. If you push the
fence tight up against the stack, it could retard feeding
and cause jams. If the clearance is too great, pieces
could skew as they feed into the printer.
SV61186ABook.indb 3-5 3/29/2004, 1:44:53 PM