Pitney Bowes ADDRESSRIGHT DA400 - Manual (Page 92)

A-31
Printer Menus
1. Adjust Print (continued)
E. Bank A to Sensor
Use this option to set this distance between the sensor
and the first head in the bank.
Set the Test Pattern printed by the bank of Print Heads to
locate the vertical bar 1/2 inch from the edge of the media.
Example: Print out an adjust print Test Pattern by press-
ing the Test button while in the Adjust Print menu. The
printer will print a Test Pattern like the example below.
Edge of media
Measure
this distance
The distance from the leading edge of the media to the
leading edge of the heavy bar on the Test Pattern should
be 1/2 inch.
If the measurement is incorrect, change the ‘offset’ setting
using the + or – buttons, then press the Enter button to
select the desired value. An Asterisk (*) will appear in front
of the new selection.
Take another test print and measure again. If necessary,
repeat the process until you obtain the leading edge mar-
gin of 1/2 inch.
Using the
Service Menu
(continued)
SV61186ABook.indb A-31 3/29/2004, 1:45:19 PM