Polycom 1 - Manual (Page 56)

Administrator’s Guide for Polycom HDX Systems
3 - 14
4. Select and configure these settings:
Setting Description
Camera 3 Specifies the VCR or DVD player’s aspect ratio:
•
4:3 — Select if you are using a VCR or DVD player in
standard mode.
• 16:9 — Select if you are using a VCR or DVD player in
wide-screen mode.
Specifies the VCR or DVD player’s format:
•
Component YPbPr — Select if the VCR or DVD player
is connected to the Polycom HDX system using a
component cable.
• S-Video — Select if the VCR or DVD player is connected
to the Polycom HDX system using an S-Video cable.
• Composite — Select if the camera is connected to the
Polycom HDX system using a composite video cable.
Name Specifies a name and icon for the VCR or DVD player.
Source Specifies whether the video source is People or Content.
Video sources specified as Content are sent at a higher
resolution and lower frame rate.
Video Quality Specifies Motion or Sharpness for the video input.
•
Motion — This setting is for showing people or other
video with motion.
• Sharpness — The picture will be sharp and clear, but
moderate to heavy motion at low call rates can cause
some frames to be dropped. Sharpness is available in
point-to-point H.263 and H.264 calls only.
Detect Camera Detects any supported PTZ camera connected to Polycom
HDX system video input 3, and configures the camera
settings accordingly. This button appears only when RS-232
Mode is set to Camera PTZ and Camera Control is set to
Camera 3 for one of the serial ports.