Pioneer VSX-D909S - Manual (Page 20)

20
Connecting Your Equipment
Placing Your Speakers
Proper speaker placement is essential to realize the best sound from your system. The diagram and tips given
here are just a rough guide; be sure to read the instructions that come with your speakers.
• Install the left and right front speakers at equal distances from the TV.
• When installing speakers near the TV, we recommend using magnetically shielded speakers to prevent
possible interference such as distortion in the color of the TV screen. If you do not have magnetically
shielded speakers and notice discoloration of the TV screen, place the speakers farther away from the TV.
• Install the center speaker above or below the TV so that the sound of the center channel is localized at
the TV screen.
CAUTION:
When installing the center speaker on top of the TV, be sure to secure it with tape or some other suitable means. Otherwise, the speaker
may fall from the TV due to external shocks such as earthquakes, and it may lead to endangering those nearby or damaging the speaker.
• If possible, install the surround speakers slightly above ear level.
• It may be difficult to obtain a cohesive surround effect if the surround speakers are installed farther
away from the listening position than the front and center speakers.
Speaker placement
If you have a multiple speaker arrangement the placement of the speakers is extremely important. To achieve the best
possible surround sound, install your speakers as shown below. Make sure all speakers are installed securely to prevent
accidents and improve sound quality. Be sure to consult your speaker manuals for the best placement of the speakers. Some
speakers are designed to be floor-standing but others benefit greatly from speakers stands which raise them off the floor.
memo
Surround
Left
Surround Back
Left
Surround
Right
Surround Back
Right
Listening
Position
Front
Left
Front
Right
Center
Sub
Woofer
Speaker impedance
You can change the speaker impedance but we recommend using speakers with an impedance of 8
Ω
-16
Ω
(the
default setting). If you are using 6
Ω
- less than 8
Ω
impedance speakers, you need to change the impedance
setting.
First turn the receiver off, then press the STANDBY/ON
button while holding down the SPEAKERS button.
Choose the impedance setting by pressing the SPEAKERS button
again. You can choose the 8
Ω
-16
Ω
setting or the 6
Ω
-8
Ω
setting.
To check which impedance
setting to hold down the
SPEAKERS button for 2-3
seconds. You'll get a display like
these telling you the speaker
impedance setting.
(This display indicates a 6
Ω
-
less than 8
Ω
impedance
setting.)
(This display indicates an 8
Ω
-
16
Ω
impedance setting.)
memo
STANDBY/ON DSP MODE
SIGNAL SELECT ADVANCED STANDARD
STANDBY
AUDIO/VIDEO MULTI-CHANNEL RECEIVER Digital Signal Processor
STEREO/ DIRECT
/DTS
VSX-D909S
PHONES S-VIDEO VIDEO
MULTI CH INPUT FL DIMMER
TAPE 2 MONITOR
TONE CHANNEL SELECT LOUDNESS DIGITAL NR CLASS BAND
TUNER CONTROL MEMORY MPX VIDEO
SELCT SPEAKERS
- TUN
- STAT - TREBLE + - BASS +
L AUDIO R VIDEO INPUT
SPEAKERS
STANDBY/ON
dB
SIGNAL
SELECT
ANALOG SP
A
VOLUME
dB
SIGNAL
SELECT
ANALOG SP
A
VOLUME