Planar PD7170 - Manual (Page 35)

Installation
Planar PD7170 Installation/Operation Manual 21
PREL
IMINA
RY
3.4
Lens Replacement
The PD7170 is shipped with the standard (1.82 – 2.28) projection lens
pre-installed. If your installation requires a different lens, proceed as follows to
remove the standard lens and replace it with the required one.
1. Using a Phillips screwdriver,
remove the two screws holding
the projector front cover in place.
2. Gently pull the cover away from
the projector at each side to
detach it.
3. Remove the cover and set it aside.
4. Locate the lens release lever, above the lens cavity.