Planar PD7170 - Manual (Page 71)

Operation
Planar PD7170 Installation/Operation Manual 57
PREL
IMINA
RY
PIP Position: To change the position of the PIP image, choose PIP Position from
the System menu; see Figure 4-13. Choose one of the following:
• Top Left: This places the PIP source into a 427x240 designated image area at
the top left of the screen.
• Top Right: This places the PIP source into a 427x240 designated image area at
the top right of the screen.
• Bottom Left: This places the PIP source into a 427x240 designated image area
at the bottom left of the screen-safe area of the DMD.
• Bottom Right: This places the PIP source into a 427x240 designated image
area at the bottom right of the screen-safe area of the DMD.
• Picture-By-Picture: This reduces the designated image area of the Active
source to 614x345 and places it next to the PIP source, which is also in a
614x345 image area. These two images are centered on the screen.
• Split Screen: This is a special mode in which the active source is also used as
the PIP source and placed in a PIP area equal to half the display on the left
side. This results in the right half of the image being the active source and the
left half is the PIP source. The PD7170 applies the User Memory 2 settings to
the PIP image.
Split-screen mode is useful for viewing “before” and “after” settings for
Sharpness, Noise Reduction and other advanced image parameters. See
Figure 4-14.
Figure 4-13. PIP and PBP areas for 720p Display
DMD Area 1280x720
Screen-Safe Area 1228x690
614x345 614x345
427x240
PIP
(1 of 4)
PBP2 PBP1