Pioneer PRO-950HD - Manual (Page 17)

17
En
Preparation 05
Note
• Before installing the speaker, make sure that the Pioneer
table top stand is attached to the plasma display.
• When using the hang on wall unit, first lay the plasma
display on top of a soft sheet, etc., remove the stand, then
attach the speaker.
1. Attach the speaker mounting fittings to the
speakers.
• There is a left speaker and a right speaker. When you are
mounting them, check the label on the back to get them
right.
• There are top and bottom speaker mounting fittings for
both the left and the right speaker. Attach the appropriate
fittings to the top and the bottom on the back of the
speakers using the supplied screws.
(It shows the attachment of the fitting on the right side. It
is attached on the left side by the same procedure.)
PRO-1150HD with the speaker installed
(with the Pioneer table top stand)
Speaker mounting fitting
(for TOP-RIGHT)
Speaker mounting screw
(M5 x 10 mm)
Speaker cable
Speaker mounting fitting
(for BOTTOM-RIGHT)
Speaker mounting screw
(M5 x 10 mm)
Speaker mounting
screw (M5 x 10 mm) Speaker mounting
screw (M5 x 10 mm)
Speaker mounting
screw (M5 x 10 mm)
Bead band
(Accessories of the
plasma display)
Speaker mounting screw
(M5 x 10 mm)
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting fitting
(for TOP-LEFT)
Speaker mounting screw
(M5 x 10 mm)
Speaker mounting fitting
(for BOTTOM-LEFT)
Speaker Speaker
Speed clamp Speed clamp
Speed clamp
Speaker mounting fitting
(For TOP-RIGHT)
Speaker mounting fitting (For TOP-RIGHT)
(The skinny slot is used for mounting to the top.)
Place the speaker so its terminals
(bottom) are facing you.
Speaker mounting fitting
(For BOTTOM-RIGHT)
Screw holes
Screw holes
Speaker mounting fitting
(For BOTTOM-RIGHT)
PRO1150HD.book Page 17 Tuesday, April 17, 2007 9:34 AM