Panduit TDP46H - Manual (Page 59)

PANDUIT TDP4*H GMTDPH-MAN Page 4-5
Section 4: Cleaning and Maintenance
7. Disconnect the signal and power cables from the
print head connectors and set the Print Head aside.
There are two connectors on the signal cable. The
smaller connector is used for the 203 and 305 dpi
print heads, the larger one for the 609 dpi print
head. Note which connector was connected to the
print head.
DO NOT remove the two outside screws (painted red)
on either side of the center mounting screw. The Print
Head is pre-aligned and if these screws are loosened,
it will have to be re-aligned for proper print quality.
8. Carefully attach the new print head to the
connectors, using caution to make sure the
connector keys are correctly positioned and that the
correct cable connector is used. The connector on
the print head should be the same size as the one
you are replacing.
NOTE: Be careful not to scratch the printing surface of
the print head while installing it. Scratching the surface will cause permanent and irreparable damage
and is not covered by the warranty!
9. Align the thumb screw with the tapped hole in the new print head.
10. Re-secure the print head by tightening the screw.
Print Head
Loosen thumb
screw
Rotate to
open head
Print Head Connector
Signal Connector. Use
correct size.