Panduit TDP46H - Manual (Page 78)

PANDUIT TDP4*H GMTDPH-MAN Page 7-2
Section 7: Optional Accessories
Plug-In Interface Modules
The TDP4*H printers have user changable Plug-In Interface Modules. The Interface Module is accessible from
the Rear Panel and is retained by two screws. Use the following procedure to replace an interface module.
1. Turn power off both the printer and the host and remove the power and interface cables.
WARNING: Never connect or disconnect interface cables (or use a switch box) with power applied to
either the host or the printer. This may cause damage to the interface circuitry and is not covered by
warranty.
2. Remove the two Interface Module Retaining Screws.
3. Grasp the Interface Module and pull it out of the connector.
4. Place the new Interface Module in the slot and press inward firmly until it is properly seated.
5. Replace the two Interface Card Retaining Screws.
6. If the new Interface Module is for a serial interface, set DSW1 for the proper operation.
7. Connect the interface cable to the connector
ERROR DESCRIPTION INDICATION REMEDY
Low Battery - Low battery
condition is detected when
printer is powered on. ERROR LED: Blinking
Audible Beep: 1 Long
Display:
Card Low
Battery
Depress LINE key to print
Card Status.
Replace Memory Card battery.
Note that all data will be lost
when the battery is removed.
Card R/W Error
1. No Card is inserted.
2. Card is write protected.
3. Invalid store/recall number.
4. Card has not been
initialized.
ERROR LED: On
Audible Beep: 1 Long
Display:
Card R/W Error
Printer must be powered off to
reset
1. Insert card into selected slot.
2. Remove write protect tab.
3. Correct program
4. Initialize card with BJF
command.
Warning
1. Duplicate number.
2. Data not in print area.
3. Data overflows card
memory.
Audible Beep: 1 Short
Display:
None
Printer will ignore invalid
commands.
1. Correct program.
2. Correct program.
3. Use card with more
capacity.