Panduit TDP46H - Manual (Page 65)

PANDUIT TDP4*H GMTDPH-MAN Page 5-5
Section 5: Troubleshooting
Error On
Machine Error 1 Long
1 Long
Machine Error 1. Defective Board.
1. EEPROM not installed correctly.
2. Overwriting EEPROM.
Error On
EEPROM Error EEPROM Read/Write
Error On 1 Long 1. Electrical head malfunction. Head Error Head
Error On 3 Short 1. Paper jam.
2. Sensor DSW setting.
3. Sensor level adjustment. Sensor Error Sensor
Error Blinks 1 Long 1. Card not formatted.
2. No card recognized. Card R/W Error Memory Card
Read/Write
Error Blinks 1 Long 1. Card battery needs replacement. Card Low Battery Memory Card
Battery Low
Error Blinks 1 Long 1. Card needs battery installed. Card Low Battery No Battery in Card
Error Blinks 3 Short 1. Head not latched.
2. Head latch switch bad. Head Open Head Open
Error Blinks 3 Short 1. Cutter jam.
2. Cutter sensor dirty. Cutter Error Cutter
Error On
Line Blinks 3 Short 1. RS232 parameter mismatch. Parity Error RS232 Parity Error
Error On
Line Blinks 3 Short 1. RS232 parameter mismatch. Overrun Error RS232 Overrun Error
Error On
Line Blinks 3 Short 1. RS232 parameter mismatch. Framing Error RS232 Framing Error
Error On
Line Blinks 3 Short 1. Command stream exceeds buffer
size.
Buffer Over Buffer Overflow
Error Blinks 3 Short 1. No paper.
2. Paper incorrectly loaded. Paper End Media End
Error Blinks 3 Short 1. Needs new ribbon roll.
2. Ribbon sensor needs adjustment. Ribbon End Ribbon End
3 Short 1. Read/Write error.
2. Corrupted download file.
3. Download file too large. Download Error
R/W Error
Mem Full Error
Download Error
3 Short 1. R/W error during copying.
2. Card not installed properly.
3. File too large. CopyCard/Format
R/W Error
No Card Error
Mem Full Error
Card Copy or
Format Error
LED LCD MESSAGE AUDIBLE BEEP ERROR CONDITION POSSIBLE CAUSES
Using the Lan Ethernet Interface
The LCD Display, Front Panel LED indicators and Buzzer provide a visual/audio indication of the type of error
encountered.