Panduit TDP46H - Manual (Page 70)

PANDUIT TDP4*H GMTDPH-MAN Page 6-4
Section 6: Interface Specifications
ELECTRICAL SPECIFICATIONS
Printer Connector AMP 57-40360 (DDK) or equivalent
Cable Connector AMP 57-30360 (DDK) or equivalent
Cable IEEE1284 Parallel, 10 ft. (3 m) or less
Signal Level High = +2.4V to +5.0V
Low = 0V to -0.4V
DATA STREAMS
<ESC>A . . Job#1 . . <ESC>Z<ESC>A . . Job#n . . <ESC>Z
IEEE1284 Parallel Interface Pin Assignments
PIN SIGNAL DIRECTION PIN SIGNAL DIRECTION
1 STROBE To Printer 19
STROBE
Return
Reference
2 DATA 1 To Printer 20 DATA 1 Return Reference
3 DATA 2 To Printer 21 DATA 2 Return Reference
4 DATA 3 To Printer 22 DATA 3 Return Reference
5 DATA 4 To Printer 23 DATA 4 Return Reference
6 DATA 5 To Printer 24 DATA 5 Return Reference
7 DATA 6 To Printer 25 DATA 6 Return Reference
8 DATA 7 To Printer 26 DATA 7 Return Reference
9 DATA 8 To Printer 27 DATA 8 Return Reference
10 ACK To Host 28 ACK Return Reference
11 BUSY To Host 29 BUSY Return Reference
12 PTR ERROR To Host 30 PE Return Reference
13 SELECT To Host 31 INIT From Host
14 AUTOFD (1) To Host 32 FAULT To Host
15 Not used 33 Not Used
16 Logic Gnd 34 Not Used
17 FG Frame Ground 35 Not Used
18 +5V (Z=24K ohm) To Host 36 SELECTIN (1) From Host
(1) Signals required for IEEE 1284 mode.