NETGEAR ProSafe WNDAP330 User Manual
Page 44
ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
2-18
Basic Installation and Configuration
v1.0, May 2008
1. From the main menu under Configuration, select Wireless, and then select the 802.11a/na tab.
The Wireless Settings screen for your 11a/n access point will display as shown in
below.
2. Configure the Wireless LAN settings based on the following field descriptions:
•
Wireless Mode. Select the desired wireless operating mode. Only 802.11a/n wireless
stations can be selected from this menu. The default is 11na. The options are:
–
11a – All 802.11a wireless stations can be used.
–
11na – All 11a and 11na wireless stations can be used. This is the default.
•
Turn Radio On. On by default, you can also turn off the radio to disable access through
this device. This can be helpful for configuration, network tuning, or troubleshooting
activities.
Figure 2-11
Note: If you select this option and if other settings on this screen are
disabled, then you must select the Turn Radio On radio button to
enable available options on this screen.