NETGEAR ProSafe WNDAP330 User Manual
Page 51
ProSafe Dual Band Wireless Access Point WNDAP330 Reference Manual
Basic Installation and Configuration
2-25
v1.0, May 2008
•
Broadcast Wireless Network Name (SSID). If you disable broadcast of the SSID, only
devices that have the correct SSID can connect. This nullifies the wireless network
“discovery” feature of some products such as Windows XP, but the data is still fully
exposed to a determined snoop using specialized test equipment like wireless sniffers.
Default is enabled.
•
Authentication Settings. Configure the following settings:
•
Network Authentication. The WNDAP330 Access Point is set by default as an open
system with no authentication. When setting up Network Authentication, bear in mind the
following:
–
If you are using Access Point mode, then all options are available. In other modes
such as Repeater or Bridge, some options may be unavailable.
–
Not all wireless adapters support WPA or WPA2. Windows XP and Windows 2000
with Service Pack 3 do include the client software that supports WPA. However, client
software is required on the client. Consult the product documentation for your
wireless adapter and WPA or WPA2 client software for instructions on configuring
WPA2 settings.
You can configure the WNDAP330 to use the types of network authentication shown in
the table below.
Table 2-1. Network Authentication Types
Type
a
Description
Open System
Can be used with WEP encryption or no encryption.
Shared Key
You must use WEP encryption and enter at least one shared key.
Legacy 802.1x
You must configure the RADIUS Server Settings to use this option.
WPA with RADIUS
You must configure the RADIUS Server Settings to use this option.
WPA2 with RADIUS
(WPA2 is a later version of WPA.)
Only select this if all clients support WPA2. If selected, you must use
AES encryption and configure the RADIUS Server Settings.
WPA and WPA2 with RADIUS
This selection allows clients to use either WPA (with TKIP) or WPA2
(with AES). If selected, you must use TKIP + AES encryption and
configure the RADIUS Server Settings.
WPA-PSK
You must use TKIP or TKIP + AES encryption and enter the WPA
passphrase (Network key).