NEC DLP CINEMA NC1600C - Manual (Page 21)

21
3. Projection of Images (Basic Operation)
3-2. Turning your projector on
Preparation: Supply AC power to the projector head.
Please contact your dealer/distributor to connect the power cable.
NOTE • Turn off the main power switch to the projector head when supplying or cutting AC power to the projector.
If power is supplied or cut while the main power switch is turned on, the projector will be damaged.
• Be sure to turn your projector on or off in two steps of operation with the “main power switch” and the
“POWER button” (“POWER ON/OFF button” on the remote control).
• Turning power on (See this page)
[1] Turn the “main power switch” on the projector head to on.
Your projector is set in a standby state.
[2] Press the POWER button (POWER ON button on the remote control) three seconds or longer.
Your projector is turn on.
• Turning power off (See page 27)
[1] Press the POWER button (POWER OFF button on the remote control) three seconds or longer.
Your projector is set in a standby state.
[2] When the fan has stopped running, set the “main power switch” on the projector head to OFF.
Your projector is turned off.
1 Remove the lens cap.
2 Turn the main power switch on the side of your projector head to on.
A buzzer will ring on the projector. The POWER indicator and rear STATUS indicator light up orange (standby state).