NEC DLP CINEMA NC1600C - Manual (Page 22)

22
3. Projection of Images (Basic Operation)
3 Press the POWER button on the control panel of your projector three seconds or longer.
Your projector is turn on, and the screen glows light about 30 seconds later. The POWER indicator of the projector lights
up green.
• When controlling with the remote control, press the POWER ON button three seconds or longer.
NOTE • While your projector is on, be sure to have the lens cap removed from the lens.
Otherwise, the lens cap may get deformed due to a heat buildup.
• In the following instances, the power to your projector cannot be turned on even if you press the POWER
button.
- When the inside temperature is abnormally high. The protective function prevents power from turning on.
Wait some time (until the projector inside cools down) and then turn on the power.
- When the STATUS indicator is blinking without the lamp lighting up after power-on. Your projector may be
in trouble. Check the error display on the LCD screen and contact your dealer/distributor for instructions.
• Note that the image may sometimes flicker until the lamp has stabilized (5 to 10 minutes) after power-on. This
is due to the characteristics of the lamp and is not trouble of your projector.