NEC DLP CINEMA NC1600C - Manual (Page 50)

50
6. Appendix
6-7-2. Remote control input connector (REMOTE IN) (Stereo mini)
Connected with the projector’s remote control the accessory remote cable.
When the remote cable is connected to this connector, the remote cable connector operates with the following functions.
DC power supply unit for remote control
Remote signal unit
GND unit
The DC voltage supplied from the projector to the remote control is approximately +4.0 V.
NOTE The remote control cable is connected first to the remote control, then to the projector head.
The leading end of the remote control cable is the power supply unit, so be careful not to touch the other end
of the remote cable to the projector head or other devices while only the remote control cable is connected
to the projector.
TIP
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Even if the remote cable power supply unit and GND unit (such as the projector head) should short, the
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
protective function inside the projector will activate to prevent the shorted cable from damaging the projector.
6-7-3. LAN port (LAN-A, LAN-B) (RJ-45)
Use Ethernet 10Base-T/100Base-TX UTP (Unshielded Twist Pair cable) to connect with a video server or a PC.
A switching hub exists inside, so there are no functional differences of either the LAN-A or LAN-B ports.
Internal Configuration Diagram of LAN Port
LAN-A
LAN-C
LAN-D
• Video Server
• PC
• Video Server
• PC
Cinema
Control
Block
Ethernet
Switching
Hub
System
Control
Block
Projector NC1600C
LAN-B
6-7-4. PC card slot
Set a wireless LAN card to control the projector from a PC using wireless LAN. When you use wireless LAN, pay attention to the
following points:
• Connection cannot be established with an NIC (Network Interface Card) of the same network group.
• Use the wireless LAN in ad hoc mode.
* The cards in the same network group have the same AND value for the IP address and the subnet mask.