NEC DLP CINEMA NC1600C - Manual (Page 24)

24
3. Projection of Images (Basic Operation)
3-4. Adjusting the position and the size of projected screen
3-4-1. Displaying the test pattern
1 Press the TEST button on the remote control. Alternatively, select the test pattern from the signal
selection button.
If you register the test patterns to the signal selection buttons (<1> to <8> buttons), select the test pattern according to
“3-3. Selecting the title of input signal (See page 23)”.
The mode for selecting the test pattern is set.
2 Press the SELECT
̇/̈ button.
The display of the test pattern name on the LCD switches.
3 Display on the LCD the name of the test pattern to be projected, then press the ENTER button.
The test pattern is displayed.
• To cancel the test pattern display, reselect the signal to be project.
3-4-2. Adjusting the position of the projected screen (Lens shift)
1 Press the [LENS CTL] UP/DOWN/LEFT/RIGHT buttons while depressing the CTL (LENS) button,
on the control panel of your projector as required.
The position of the projected screen will move upward, downward, left or right.
• When controlling with the remote control, press the POSI/LENS button while depressing the CTL button.