NETGEAR ProSafe FVS124G - Manual (Page 52)

Reference Manual for the ProSafe VPN Firewall 25 with 4 Gigabit LAN and Dual WAN Ports
4-8 Connecting the FVS124G to the Internet
202-10085-01, March 2005
Figure 4-2: Login screen on the Web browser
2. For security reasons, the firewall has its own user name and password. When prompted, enter
admin
for the firewall user name and
password for the firewall password, both in lower case
letters.The firewall user name and password are not the same as any user name or password
you may use to log in to your Internet connection.
Step 3: Configure the Internet Connections to Your ISPs
(Required)
The steps to configure the Internet connections to your ISPs are to configure WAN port 1 first and
then configure WAN port 2 second.
1. The steps to configure WAN port 1 are as follows:
a. You should now be connected to the firewall. If you do not see the WAN1 ISP Settings
screen shown in
Figure 4-3 , click the WAN1 ISP link directly under WAN Setup on the
upper left of the main menu.
Note: You might want to enable remote management at this time so that you can log in
remotely in the future to manage the firewall. See “Enabling Remote Management
Access” on page 8-9 for more information. Remote management enable is cleared with
a factory default reset.
Whenever you enable remote management, you are strongly advised to change your
password. See
“Changing the Passwords and Login Timeout” on page 8-8 for the
procedure on how to do this.