NEC PD78058FY(A) - Manual (Page 77)

77
CHAPTER 4 PIN FUNCTION (
µ
PD78058FY SUBSERIES)
4.1 Pin Function List
4.1.1 Normal operating mode pins
(1) Port pins (1/3)
Pin Name Input/Output Function After Reset Alternate Function
P00 Input Port 0. Input only Input INTP0/TI00
P01 Input/ 8-bit input/output port. Input/output mode can be specified Input INTP1/TI01
P02 output bit-wise. INTP2
P03 If used as an input port, an on-chip INTP3
P04 pull-up resistor can be used by INTP4
P05 software. INTP5
P06 INTP6
P07 Note 1 Input Input only Input XT1
P10 to P17 Input/ Port 1. Input ANI0 to ANI7
output 8-bit input/output port.
Input/output mode can be specified bit-wise.
If used as input port, an on-chip pull-up resistor can be used by
software Note 2 .
P20 Input/ Port 2. Input SI1
P21 output 8-bit input/output port. SO1
P22 Input/output mode can be specified bit-wise. SCK1
P23 If used as an input port, an on-chip pull-up resistor can be used by STB
P24 software. BUSY
P25 SI0/SB0/SDA0
P26 SO0/SB1/SDA1
P27 SCK0/SCL
Notes 1. When the P07/XT1 pin is used as an input port, set the bit 6 (FRC) of the processor clock control register
(PCC) to 1 (do not use the feedback resistor internal to the subsystem clock oscillator).
2. When using pins P10/ANI0 to P17/ANI7 as analog input for the A/D converter, set port 1 to the input
mode. The on-chip pull-up resistor will be automatically disabled.