NEC WT615 - Manual (Page 115)

108
The Security function takes effect.
To register a PC card as a protect key.
1. Insert a PC card into the PC card slot of the projector.
2. Use the SELECT
̆
or
̄
button to select "Use Protect Key" and press the ENTER button.
3. Use the SELECT
̆
or
̄
button to select "Read" and press the ENTER button.
Data of the PC card will be read into the projector.
4. Use the SELECT ̆ or ̄ button to select "Register" and press the ENTER button.
Downloaded data will be registered and be displayed in the list window.
5. Use the SELECT
̆
or
̄
button to select "Keyword" and use the software keyboard to enter a keyword.
NOTE: To use a PC card as a protect key, you must also set up a keyword. Please make a note of your keyword.
This completes registration of your PC card.
To enable Security, use the SELECT
̆ or ̄ button to select "Enable" and use the SELECT ̆ or ̄ button to select
"OK" and "Security function will be enabled. An “Are you sure?" message will appear. Use the SELECT
̇ or ̈ button
and press the ENTER button.
The Security function takes effect.
To turn on the projector when Security is enabled (when using your keyword only).
1. Press and hold the POWER button for a minimum of two seconds.
The projector will be turned on and display a message to the effect that the projector is security-pro-
tected.
2. Press the MENU button.
The Release Code input screen will be displayed.
3. Enter your keyword in the Release Code input screen.
You can view the projected image.
NOTE: Do not forget your keyword. However, if you forget your keyword, NEC or your dealer will provide you with your Release
Code. See more information at the end of this section.
6. Using On-Screen Menu