NEC WT615 - Manual (Page 145)

138
8. Appendix
ᕡ Troubleshooting
This section helps you resolve problems you may encounter while setting up or using the projector.
Indicator Messages
POWER Indicator
Indicator Condition Projector Condition Note
Off
Blinking light
Steady light
Green
Orange
Green
Orange
0.5 sec On,
0.5 sec Off
2.5 sec On,
0.5 sec Off
0.5 sec On,
0.5 sec Off
The main power is off
The projector is getting ready to turn on.
Off Timer is activated.
The projector is cooling down.
The projector is turned on.
The projector is in Normal standby or
Power-saving standby mode.
–
Wait for a moment.
–
Wait for a moment.
–
–
STATUS Indicator
Indicator Condition Projector Condition Note
Off
Blinking light
Steady light
Red
Green
Orange
Orange
Red
Green
1 cycle (0.5 sec On,
2.5 sec Off)
2 cycle (0.5 sec On,
0.5 sec Of)
3 cycle (0.5 sec On,
0.5 sec Off)
4 cycle (0.5 sec On,
0.5 sec Off)
6 cycle (0.5 sec On,
0.5 sec Off)
1 cycle(0.5 sec On,
2.5 sec Off)
Normal
Lamp cover error
Temperature error
Temperature error due to dust
Power error
Fan error
Lamp error
Re-firing the lamp (The projector is cool-
ing down.)
Network conflict
Cabinet button is locked
A hand or an object blocks the light path.
The projector is in Normal standby mode.
–
Replace the lamp cover correctly.
(Page
136 )
The projector is overheated. Move
the projector to a cooler location.
Remove dust in the light path.
Power unit will not work correctly.
Fans will not work correctly.
Lamp fails to light. Wait a full
minute and then turn on again.
The projector is re-firing. Wait for a
moment.
Network will not work correctly.
You have pressed cabinet button
when Cabinet Button is locked.
(Page
105 )
Remove it from the light path.
–
LAMP Indicator
Indicator Condition Projector Condition Note
Off
Blinking light
Steady light
Normal
Lamp has reached its end of life. Lamp
replacement message will be displayed.
Lamp has been used beyond its limit. The
projector will not turn on until the lamp is
replaced.
Lamp mode is set to Eco mode
Red
Red
Green
–
Replace the lamp.
(Page 134 )
Replace the lamp.
(Page 134 )
–