NEC EXPRESS5800 N8800-099F - Manual (Page 119)

Troubleshooting 6-7
Welcome to Setup.
This portion of the Setup program prepares Microsoft(R)
Windows(R) to run on your computer.
- To set up Windows now, press ENTER.
- To repair a Windows installation using
Recovery Console, press R.
- To quit Setup without installing Windows, press F3.
The driver you provided seems to be newer than the Windows default driver.
Windows already has a driver that you can use for
“Adaptec Ultra320 SCSI Cards (Win XP/Server 2003 IA-32)”.
Unless the device manufacturer prefers that you use the driver on the floppy
disk, you should use the driver in Windows.
Setup will load support for the following mass storage device(s):
Adaptec Ultra320 SCSI Cards (Win XP/Server 2003 IA-32)
(c) Select all SCSI adapter list in the floppy disk and then press Enter.
[Adaptec Ultra320 SCSI Cards (Win XP/Server 2003 IA-32)]
(d) When the following screen appears, press the S key.
(e) When the following screen appears, remove the floppy disk from the floppy disk drive
and press the Enter key.
Continue the operations by following the messages.
4. When you start up Recovery Console from Windows Server 2003 CD-ROM, the following
message appears. Press the R key to boot Recovery Console.
IMPORTANT:
„ The message shown above does not appear when you have started up the
Recovery Console installed on the system.
5. Follow the messages on the screen to start up the Recovery Console.
IMPORTANT: