NEC EXPRESS5800 N8800-099F - Manual (Page 129)

Troubleshooting 6-17
About the Express Setup
The following message appeared when installation has been attempted by using a hard disk drive
whose size is smaller than the specified partition size:
o The message does not mean there is a problem. Press the Enter key to continue the
installation.
The screen did not show image correctly while files were copied from the CD-ROM or the
CD-ROM was being checked.
o Press the R key. If the problem persists after you have press the R key for several times,
start the Express Setup from the beginning again. If you still see the same result, contact
your service agent to check the CD-ROM drive.
Automatic installation halted asking you to enter the setup information.
o The setup information you have configured is not correct. Enter correct values according
to the message instructions. You do not need to cancel the installation. You may be
required to press the Enter key again at the reboot at the end of a setup in Windows.
[OK] appears on the [Role of Computer] window.
o When you click [OK], in the rest of procedures, the default values of the Express Setup
are automatically selected for the installation.
<Default values>
Network protocol settings
Protocol: TCP/IP [DHCP specified]
Service: Selecting sharing files for Microsoft network and printer
Client: client for Microsoft networks
Component: SNMP
Application: NEC ESMPRO Agent
[OK] does not appear on the [Role of Computer] window.
o [OK] does not appear if the setup information file that has been created is loaded.
o [OK] appears only when you have moved to the [Role of Computer] window. Once you
have moved to the next window from the [Role of Computer] window, [OK] does not
appear even if you use [Back].
The specified partition size has exceeded the capacity of the hard disk. The setup
created the partition at the maximum size that can be reserved on the hard disk.
Setup will continue the process.