Nortel Networks Sun Fire V100 - Manual (Page 22)

NN10287-301 MCS 5100 3.5 Standard 5.0 December 2006
22 Copyright © 2006 Nortel Networks
Recommended hardware for this configuration consists of four (4) Sun
Fire V100 servers. The servers include:
• two (2), cat-5 Ethernet cables for each V100 server (for a total of
eight (8) ethernet cables)
Note: Each V100 server uses two (2) ethernet cables to connect
the V100 servers to the layer-2 switch.
• two (2) serial (NTVW01IM cable for Terminal server) cables for each
V100 server (or a total of eight (8) serial cables)
Note: Serial cables are ordered with the MRV terminal server.
— one (1) cable for Serial Port A (LOM)
— one (1) cable for Serial Port B
• one (1) power cable
• LAN connection to the Layer-2 switch (Refer to layer-2 switch
customer documentation for layer-2 switch settings.)
• Sun Fire V100 server documentation
• 40-GB hard drive (two [2] drives in each server for disk mirroring)
• 1-GB total memory
• Terminal server connected to the diag port
ATTENTION
You need to have the following:
• Business Policy Switch 2000 (BPS 2000) or Layer-2 switch
Check your vendor documentation for configuring your Layer-2
switch.
• one (1) additional cat-5 ethernet cable to connect the MRV
terminal server to the layer-2 switch
• a PC for the management console, and access to the network
WARNING
Static electricity could be harmful to the server.