Nortel Networks Sun Fire V100 - Manual (Page 69)

MCS 4-server Sun Fire V100 Solaris Installation and Commissioning Guide
69 Copyright © 2006 Nortel Networks
Refer to this table when entering the following command:
cd [space] /IMS/ora_cds/Disk1 [Enter]
./Oracle_Install PRIMARY <primarydb-hostname> [space]
<secondarydb-hostname>[space] | [space] tee [space]
/tmp/oracleinstall.log
11 Enter the password oracle at the Oracle prompt. [Enter]
12 Retype the password: oracle [Enter]
13 Select the database configuration:
1) Enterprise
2) Carrier
Accept the default [1]
[Enter]
14 Is the database replicated [N]? Accept the default [N]
[Enter]
15 You will then see a confirmation screen. If the information on the
screen is correct, type Y. Otherwise, type N and make the
changes.
Note: At this point, the program runs a check sum and untars
the files to the local directory. Approximate time: 30 - 45
minutes.
ATTENTION
In step 10 you will enter the hostname twice. The
sec_db_hostname is the same as the pri_db_hostname for a
4-server non-redundant configuration.
Prompt Definition Enter
pri_db_hostname There is only one
hostname for a
4-server configuration. Hostname of the
database server, for
example, db.
sec_db_hostname Since there is no
secondary server,
enter again the
pri_db_hostname
(Hostname of the
database server). Re-enter hostname of
the database server.