Nortel Networks Sun Fire V100 User Manual
Page 43
MCS 4-server Sun Fire V100 Solaris Installation and Commissioning Guide
43
Copyright © 2006 Nortel Networks
Solaris Installation Program Page
1
Press Esc, then press the number 2 [Esc+2] to continue.
Note: If you are using a direct console connection to the SUN
terminal, use the F2 key.
2
Press Esc+2 to continue.
Network Connectivity/Networked
3
Accept the default Yes by pressing Esc+2 to continue.
DHCP/Use DHCP
4
Accept the default No by pressing Esc+2 to continue.
Primary Network Interface /Primary Network Interface
5
Accept the default dmfe0 interface by pressing Esc+2 to
continue.
Host name/Host name
6
Enter the host name of the server, for example: db
Note 1: Host name cannot start with a number. Host names
must be at least two characters and can contain alphanumeric
characters and minus signs (-).
Note 2: Host names must be unique within your domain.
Creating a duplicate host name will cause problems on the
network after you install Solaris.
Press Esc+2 to continue.
IP Address
7
Enter the machine logical IP address.
Example: 192.168.14.21
Press Esc+2 to continue.
ATTENTION
Make sure you enter the machine logical IP address for this
system. It must be unique and follow your site’s address
conventions.