Installing cd3 – Nortel Networks Sun Fire V100 User Manual
Page 47
MCS 4-server Sun Fire V100 Solaris Installation and Commissioning Guide
47
Copyright © 2006 Nortel Networks
Procedure 11 Installing CD2
At the management pc,
1
Place CD2 in the CD-ROM drive and press Enter. You will see a
number of messages requiring no specific answer. Press Enter
following each one.
2
You will then see the following message: What type of
installation are you performing? 1=Typical;
2=Custom
Type 1 and press Enter.
3
You will then see the following message: Ready to Install:
Install Now, Start Over, Exit Installation
Type 1 for Install Now and press Enter.
4
Press Enter several more times to complete the License
Agreement.
Note: You will now see a progress bar showing percent of
installation completed.
5
You will then be asked to choose 1 for Live Install or 2 for Done.
Accept the default 2-Done by pressing Enter.
Note 1: CD2 will eject from the CD-ROM drive when
installed.
Note 2: The system will reboot and come up requesting that
you insert MCS Base Platform System Software CD3.
Installing CD3
Approximate time estimate = 90 minutes
ATTENTION
If you are not prompted for CD3, contact support.