NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 35)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Quick Startup 6-3
202-10010-01
Quick Startup Physical Port Data
Table 6-2. Quick Startup Physical Port Data
Quick Startup User Account Management
Command Details
show port all Displays the Port Characteristics
Slot.Port - slot number.port number
Slot Options:
0 - the port is one of the physical ports
1 - a link aggregation group (LAG). The port number field in this case refers to the
LAG group ID.
3 - a VLAN group. The port field starts with 1 as the first VLAN group created in the
switch.
Port (when Slot value is 0):
Ports 1-24 are gigabit copper ports, ports 21-24 can also be used as fiber
ports
Type - indicates if the port is a special type of port
STP State - displays the Spanning Tree status
Admin Mode - selects the Port Control Administration State
Physical Mode - selects the desired port speed and duplex mode
Physical Status - indicates the port speed and duplex mode
Link Status - indicates whether the link is up or down
Link Trap - determines whether or not to send a trap when link status changes
LACP Mode - displays whether LACP is enabled or disabled on this port.
Table 6-3. Quick Startup User Account Management
Command Details
show users Displays all of the users that are allowed to access the switch
Access Mode - Shows whether the user is able to change
parameters on the switch (Read/Write) or is only able to view then
(Read Only).
As a factory default, admin has Read/Write access and guest has
Read Only access. There can only be one Read/Write user and up
to 5 Read Only users.