NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 56)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-14 Switching Commands
202-10010-01
• Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual
address (b'0') or a group address (b'1').
• The second character, of the twelve character macAddr, must be 2, 6, A or E.
A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').
Format config network macaddr <macAddr>
config network mactype
This command specifies whether the burnedin MAC address or the locally-administered MAC
address is used.
Default burnedin
Format config network mactype <local|burnedin>
config network parms
This command sets the IP Address, subnet mask and gateway of the router. The IP Address and the
gateway must be on the same subnet.
Format config network parms <ipAddr> <netmask> [gateway]
config network protocol
This command specifies the network configuration protocol to be used. If you modify this value
change is effective immediately. See “save config” on page 74 for more information.
Default none
Format config network protocol <none|bootp|dhcp>, where bootp
indicates that the switch periodically sends requests to a Bootstrap Protocol
(BootP) server or a dhcp server until a response is received. none indicates that
the switch should be manually configured with IP information.
config network webmode
This command enables or disables access to the switch through the Web interface. When access is
enabled, the user can login to the switch from the Web interface. When access is disabled, the user
cannot login to the switch's Web server.
Disabling the Web interface takes effect immediately. All interfaces are effected.