NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 94)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-52 Switching Commands
202-10010-01
config spanningtree cst port priority
This command sets the Port Priority to a new value for use within the common and internal
spanning tree. The <slot.port> is the desired switch port. The priority <value> is a number in the
range of 0 to 240 in increments of 16.
Default 128
Format config spanningtree cst port priority <slot.port> <0-
240>
config spanningtree cst port edgeport
This command specifies if a port is an Edge Port within the common and internal spanning tree.
This will allow the port to transition to Forwarding State without delay. The <slot.port> is the
desired switch port. The edgeport <value> can either be "true" or "false".
Default false
Format config spanningtree cst port edgeport <slot.port>
<true/false>
config spanningtree mst create
This command adds a multiple spanning tree instance to the switch. The instance <mstid> is a
number within a range of 1 to 4094, that corresponds to the new instance ID to be added. The
maximum number of multiple instances supported by managed switch software is 4.
Format config spanningtree mst create <mstid>
config spanningtree mst delete
This command removes a multiple spanning tree instance from the switch and reallocates all
VLANs allocated to the deleted instance to the common and internal spanning tree. The instance
<mstid> is a number that corresponds to the desired existing multiple spanning tree instance to be
removed.
Format config spanningtree mst delete <mstid>