NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 39)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Quick Startup 6-7
202-10010-01
Quick Startup Downloading from TFTP Server
Before starting a TFTP server download, the operator must complete the Quick Startup for the IP
Address.
Quick Startup Factory Defaults
Table 6-7. Quick Startup Downloading from TFTP Server
Command Details
transfer download mode TFTP Makes the download mode to be TFTP
transfer download datatype <config/code> Sets the download datatype to be an image or
config file.
The default is a code file.
transfer download filename <name> The name can ONLY be an image file or a
configuration file of the switch.
transfer download serverip <ipAddr> The IP Address is the source IP Address.
transfer download start Starts the TFTP download
Table 6-8. Quick Startup Factory Defaults
Command Details
clear config Enter yes when the prompt pops up to clear all the configurations
made to the switch.
save config Enter yes when the prompt pops up that asks if you want to save the
configurations made to the switch.
reset system OR Cold Boot the
Switch Enter yes when the prompt pops up that asks if you want to reset the
system.
This is the users choice either reset the switch or cold boot the
switch, both work effectively.