NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 102)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-60 Switching Commands
202-10010-01
Format config radius accounting mode <enable/disable>
config radius accounting server add
This command configures the IP address to use for the accounting server. Only a single accounting
server can be configured. If an accounting server is currently configured it must be removed using
the ‘config radius accounting server remove’ command before the add command will succeed.
Format config radius accounting server add <ipaddr>
config radius accounting server port
This command configures the UDP port to use for the accounting server. The IP address specified
must match that of the previously configured accounting server. If a port is already configured for
the accounting server, the new port will replace the previously configured value. The port must be
a value in the range of 0 and 65535.
Default 1813
Format config radius accounting server port <ipaddr> <0-65535>
config radius accounting server remove
This command removes a configured accounting server. The IP address specified must match that
of the previously configured accounting server. Since only a single accounting server is supported,
issuing this command will cause future accounting attempts to fail.
Format config radius accounting server remove <ipaddr>
config radius accounting server secret
This command configures the shared secret between the RADIUS client and the RADIUS
accounting server. The IP address specified must match that of the previously configured
accounting server. When this command is issued, the secret will be prompted. The secret must be
an alphanumeric value of 20 characters or less.
Format config radius accounting server secret <ipaddr>