NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 36)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
6-4 Quick Startup
202-10010-01
Quick Startup IP Address
To view the network parameters the operator can access the device by the following three
methods.
• Simple Network Management Protocol - SNMP
• Telnet
• Web browser
Note: Helpful Hint - do a save config after changing the network parameters so that the
configurations are not lost.
show loginsession Displays all of the login session information
config users passwd <user> Allows the user to set passwords or change passwords needed to
log in.
A prompt appears requesting the users old password. In the
absence of an old password leave the area blank. The operator
must press enter to execute the command.
The system then prompts the user for a new password then a
prompt to confirm the new password. If the new password and the
confirmed password match a message is displayed.
save config This command saves passwords and all other changes to the
device.
If you do not issue this command, all configurations will be lost
when a power cycle is performed on the switch or when the switch
is reset.
logout Logs the user out of the switch
Table 6-4. Quick Startup IP Address
Command Details
show network Displays the Network Configurations
IP Address - IP Address of the interface
Default IP is 0.0.0.0
Subnet Mask - IP Subnet Mask for the interface
Default is 0.0.0.0
Table 6-3. Quick Startup User Account Management
Command Details