NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 38)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
6-6 Quick Startup
202-10010-01
Quick Startup Uploading from Switch to Out-of-Band PC (Only
XMODEM)
Quick Startup Downloading from Out-of-Band PC to Switch (Only
XMODEM)
Table 6-5. Quick Startup Uploading from Switch to Out-of-Band PC (Only XMODEM)
Command Details
transfer upload mode xmodem Changes mode to xmodem which is initiated by the
serial EIA 232 port
transfer upload datatype
<config|errorlog|systemtrace|traplog>
The types are:
config - configuration file
errorlog - error log
system trace - system trace
traplog - trap log
transfer upload start This starts the upload and also displays the mode of
uploading and the type of upload it is and confirms
the upload is taking place.
For example:
If the user is using HyperTerminal, the user must
specify where the file is going to be received by the
PC.
Table 6-6. Quick Startup Downloading from Out-of-Band PC to Switch (Only XMODEM)
Command Details
transfer download mode xmodem Makes the download mode to be xmodem
transfer download datatype <config/code> Sets the download datatype to be an image or
config file.
The default is a code file.
transfer download start For example:
If the user is using HyperTerminal, the user must
specify which file is to be sent to the switch.
The Switch restarts automatically once the code
has been downloaded.