NETGEAR 7200 Series Layer 2 Managed Switch Software - Manual (Page 54)

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
7-12 Switching Commands
202-10010-01
show eventlog
This command displays the event log, which contains error messages from the system. The event
log is not cleared on a system reset.
Format show eventlog
File The file in which the event originated.
Line The line number of the event.
Task Id The task ID of the event.
Code The event code.
Time The time this event occurred.
Note: Event log information is retained across a switch reset.
show msglog
This command displays the message log maintained by the switch. The message log contains
system trace information.
The trap log contains a maximum of 256 entries that wrap.
Format show msglog
Message The message that has been logged.
Note: Message log information is not retained across a switch reset.
show traplog
This command displays the trap log maintained by the switch.
The trap log contains a maximum of 256 entries that wrap.
Format show traplog
Number of Traps since
last reset The number of traps that have occurred since the last reset of this device.
Number of Traps since log
last displayed The number of traps that have occurred since the traps were last displayed.
Getting the traps by any method (terminal interface display, Web display, upload
file from switch etc.) will result in this counter being cleared to 0.
Log The sequence number of this trap.
System Up Time The relative time since the last reboot of the switch at which this trap occurred.
Trap The relevant information of this trap.
Note: Trap log information is not retained across a switch reset.