Config macfilter remove, Config macfilter addsrc, Config macfilter delsrc – NETGEAR 7200 Series Layer 2 Managed Switch Software User Manual

Page 86: Config macfilter remove -44, Config macfilter addsrc -44, Config macfilter delsrc -44

Advertising
background image

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

7-44

Switching Commands

202-10010-01

The <vlan> parameter must identify a valid VLAN.

Up to 100 static MAC filters may be created.

Format

config macfilter create <macaddr> <vlan>

config macfilter remove

This command removes all filtering restrictions and the static MAC filter entry for the MAC
address <macaddr> on the VLAN <vlan>. The <macaddr> parameter must be specified as a 6-byte
hexadecimal number in the format of b1:b2:b3:b4:b5:b6.

The <vlan> parameter must identify a valid VLAN.

Format

config macfilter remove <macaddr> <vlan>

config macfilter addsrc

This command adds the <slot.port> to the source filter set for the MAC filter with the MAC
address of <macaddr> and VLAN of <vlan>. The <macaddr> parameter must be specified as a 6-
byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.

The <vlan> parameter must identify a valid VLAN.

The <slot.port> parameter identifies the source port to be added to the source port filter set for the
MAC filter.

If all is selected, all ports will be added to the source port filter set.

Format

config macfilter addsrc <macaddr> <vlan>

<slot.port|all>

config macfilter delsrc

This command removes a port from the source filter set for the MAC filter with the MAC address
of <macaddr> and VLAN of <vlan>. The <macaddr> parameter must be specified as a 6-byte
hexadecimal number in the format of b1:b2:b3:b4:b5:b6.

The <vlan> parameter must identify a valid VLAN.

The <slot.port> parameter identifies the source port to be removed from the source port filter set
for the MAC filter.

Advertising