Navini Networks Ripwave 40-00097-00 - Manual (Page 27)

Navini Networks, Inc. Ripwave Modem User Guide
Part #40-00097-00 Rev E v1.0 Copyright © 2003 Navini Networks, Inc. All rights reserved. 27
July 30, 2003
Using Navini
Monitor, continued
To check connectivity to the Service Provider’s network, you will
click the Advanced button on the Navini Monitor. The Advanced
section of the window appears and displays all of the connections
throughout the network. The names of the network component will
vary with each Operator’s network. Note that if the connection
between the Ripwave Modem and the Base Station is down, the
Advanced button will be disabled (grayed out).
The blue question marks on the right side of the Advanced section
indicate that all connections are untested. Now click on the Run
Tests button at the bottom of the window. The blue question marks
will change to either a blue checkmark or a red slash mark. A blue
checkmark indicates that the connection is valid. A red slash mark
indicates there is a problem with that connection.
The features of the Advanced and Run Tests buttons are to be used
in conjunction with your Service Provider Technician to resolve
problems. There is no need to use these features unless you are
experiencing problems with the Modem.