Navini Networks Ripwave 40-00097-00 - Manual (Page 9)

Navini Networks, Inc. Ripwave Modem User Guide
Part #40-00097-00 Rev E v1.0 Copyright © 2003 Navini Networks, Inc. All rights reserved. 9
July 30, 2003
Minimum
Computing
Requirements
(See, also, Addendum 1)
Operating
System
1 :
Ethernet Modems: Any Win32 ® Operating System
(OS) - Windows ® 95, Windows 98 2 , Windows
98SE 2 , Windows 2000, Windows ME 2 , Windows
XP, or later version. Windows XP must be Service
Pack Level 1 or higher. Internet Explorer 3.0 or
higher is required for installation on Windows 95
Operating Systems.
USB Modems: Windows
® 98 2 , Windows 98SE 2 ,
Windows 2000, Windows ME 2 , Windows XP,
or later version. USB will not work with Windows
95 or Windows NT. Windows XP must be Service
Pack Level 1 or higher.
General Information:
Ensure that the pc network port is enabled.
MacIntosh systems and Lynx/Unix systems are
not supported.
CPU: Pentium level or higher
RAM: 32 MB or the Operating System minimum,
whichever is greater
Hard Drive: 10 MB free disk space for Navini Monitor software
Monitor: 256 colors, 800 x 600 resolution
1 NOTE: If you are going to upgrade your Operating System after loading the
Navini Monitor software, you must first uninstall Navini Monitor prior to
upgrading the OS. Otherwise, Navini Monitor will not work. See
Uninstall
instructions in this Guide.
2 NOTE: The Ripwave Modem must be left powered ON whenever you shut
down or restart any Windows 98 or ME platforms. If the Modem is off, a blue
screen appears on the monitor. In the event that happens you will most likely
have to power cycle the PC.
The Ripwave Modem installation sections include instructions for
both Ethernet and USB connections. Be sure to use the instructions
that apply to your Ripwave model. The Navini Monitor software
installation procedure is the same for any of the Ripwave models.
This manual will guide you through the simple process of installing
the Ripwave Modem and software, which has been developed to
optimize the ease and convenience for you, our valued customer.
The 2.6 GHz model is used in most of the illustrations in this
manual where there are no differences in the 2.3, 2.4, 2.5, and 2.6
GHz models.
If you experience any difficulties with your unit, please contact
your Service Provider or the vendor from whom you obtained your
Ripwave Modem.