Navini Networks Ripwave 40-00097-00 - Manual (Page 29)

Navini Networks, Inc. Ripwave Modem User Guide
Part #40-00097-00 Rev E v1.0 Copyright © 2003 Navini Networks, Inc. All rights reserved. 29
July 30, 2003
Installing &
Charging the
Battery
2.4 GHz Battery
The battery pack is an option and is not included with the unit. To
order a battery for the Ripwave Modem, contact your Service
Provider or the vendor from whom you purchased the Modem.
The battery pack is installed in the bottom of the Ripwave Modem.
The battery compartment of the 2.4 GHz Ripwave Modem varies
from the 2.3, 2.5, and 2.6 GHz models. To install and charge or
remove the battery pack, follow the steps based on your model.
Step Action
Illustration
1. Squeeze both tabs to
remove or install the
battery pack cover.
Note that the cover is
not used when the
battery pack is installed
in the Modem.
2.
Install the battery pack
into the Ripwave
Modem, ensuring that
the contacts on the
battery pack mate with
the contacts in the
Modem and that both
slides snap down
securely.
3. To charge the battery,
connect the AC adapter
to the Modem and to an
AC power source. The
battery will begin
charging immediately
regardless of whether
the On/Off switch is on.
However, the pack will
charge faster if the
on/off switch is in the
OFF position.
If the on/off switch is
ON, the light indicator
will be constant yellow.
When fully charged, the
light will go off.
Battery contacts Battery contacts
Battery Pack Cover tabs Battery Pack Cover tabs
.
.
.
Battery
Indicator
.
.
.
Battery
Indicator