Adjust the tilt foot – NEC NP40 User Manual
Page 29
21
LAM
P
ST
ATU
S
PO
WE
R
ON
/STA
ND
BY
SOU
RCE
AU
TO
AD
J.
SELE
CT
FO
CU
S
2
1
S-VIDEO IN
VIDEO IN
COMPUTER IN
PC CONTROL
SO
UR
CE
AU
TO
ADJ.
SELECT
ON/STAND BY
LAMP
STATUS
POW
ER
FOCUS
AC IN
3. Projecting an Image (Basic Operation)
Adjust the Tilt Foot
1. Lift the front edge of the projector.
CAUTION:
Do not try to touch the ventilation outlet during Tilt Foot adjust-
ment as it can become heated while the projector is turned on and
during its cool down period after it is turned off.
2. Push up and hold the Adjustable Tilt Foot Button on the front
of the projector to extend the adjustable tilt foot (maximum
height).
3. Lower the front of the projector to the desired height.
4. Release the Adjustable Tilt Foot Button to lock the adjustable
tilt foot.
There is approximately 10 degrees (up) of adjustment for the front
of the projector.
Adjusting the height of a projected image or changing the projec-
tion angle will result in the Auto Keystone function quickly cor-
recting the vertical distortion.
Adjustable Tilt Foot
Adjustable Tilt
Foot Button
Ventilation (outlet)
CAUTION:
Do not use the tilt-foot for purposes other than originally intended.
Misuses such as using the tilt foot to carry or hang (from the wall or
ceiling) the projector can cause damage to the projector.
NOTE: The rear foot height can be adjusted up to 0.16 inch/4 mm (1 degree of
angle). Rotate the rear foot to the desired height in order to square the image
on the projection surface. Do not extend the rear foot over 0.16" (4 mm). Do-
ing so will cause the rear foot to come free off the bottom.
Rear foot
Up
Down
LAM
P
STA
TUS
PO
WE
R
ON
/STA
ND
BY
SOUR
CE
AUT
O
AD
J.
SE
LE
CT
FO
CU
S
3