7) turning off the projector, 8) after use, Turning off the projector ❽ after use – NEC NP40 User Manual

Page 35: Turning off the projector, After use, Projecting an image (basic operation), Caution

Advertising
background image

27

AUTO
ADJ.

ON/STAND BY

FOCUS

LAMP

STATUS

POWER

SELECT

Turning off the Projector

To turn off the projector:

3. Projecting an Image (Basic Operation)

ENTER

EXIT

MENU

UP

PAGE

OFF

POWER

ON

PIC-MUTE

DOWN

FOCUS

First, press the POWER (ON/STAND BY) button on the
projector cabinet or the POWER OFF button on the re-
mote control. The “Power Off / Are you sure?” message
will appear.

After Use

Preparation: Make sure that the projector is turned off.

1. Unplug the power cable.
2. Disconnect any other cables.
3. Retract adjustable tilt foot and rear foot if extended.
4. Cover the lens with the lens cap.
5. Put the projector and its accessories in the supplied soft case.

Secondly, press the ENTER button or press the POW-
ER (ON/STAND BY) or the POWER OFF button again.
The power indicator will glow orange.
Immediately after turning on the projector and display-
ing an image, you cannot turn off the projector for 60
seconds.

POWER

STATUS

LAMP

POWER

STATUS

LAMP

POWER

STATUS

LAMP

Power On

Fan running

Standby

Steady green light

Blinking or-

ange light

Steady orange

light

CAUTION:

Parts of the projector will become heated during operation. Use caution when picking up the projector immedi-
ately after it has been operating.

CAUTION:

Use caution when putting the projector in the soft case immediately after the projector has been operating.
The projector cabinet is hot.

About Direct Power Off

The projector has a feature called "Direct Power Off". This feature allows you to unplug the projector when project-
ing an image.

NOTE: Do not turn off the projector using the "Direct Power Off" function within 10 seconds of making adjustment or setting
changes and closing the menu. Doing so can cause loss of adjustments and settings.

Advertising