NEC MT830 - Manual (Page 11)

E-10
5 RGB Input 2 Connector (Mini D-Sub 15 pin)
Connect a Macintosh or compatible computer here using the
signal cable and the monitor adapter that is supplied. Or
connect your PC or other RGB equipment such as IBM or
compatible computers. Use the signal cable that is supplied
to connect to a PC.
RGB 2 Audio Input Mini Jack
This is where you connect a second RGB audio output from
a computer or another RGB source.
6 PC Control Port
Use this port to connect your PC to control the MultiSync
MT830/1030 Projector. This enables you to use your PC and
serial communication protocol to control the projector. If
you are writing your own program, command references are
on page E-45.
A cap is put on the port at the factory. Remove the cap when
using the port.
7 Mouse Output Port
Use this port to operate your computer’s mouse functions
from the NEC MultiSync MT830/1030 remote control.
When your computer is connected here, the remote sensors
on the LCD projector cabinet will receive your mouse com-
mands.
8 Remote Control Jack
Connect your remote control cable here for wired operation.
9 Built-in Security Slot ( )
This security slot supports the MicroSaver ® Security Sys-
tem.
MicroSaver ® is a registered trademark of Kensington
Microware Inc. The logo is trademarked and owned by
Kensington Microware Inc.
PC CONTROL MOUSE OUTPUT REMOTE
CONTROL
INPUT
AUDIO R G B I N P U T 2 AUDIO R G B I N P U T 1
AUDIO R G B M O N I T O R O U T P U T
R L / M O N O
I N P U T A U D I O S – V I D E O
R L / M O N O
I N P U T A U D I O V I D E O
6 7 8
5
9
AC IN