NEC MT830 - Manual (Page 12)

E-11
Remote Control Features
You can use your remote control with the cable or wireless to
operate your MultiSync MT830/1030 LCD Projector. With the
mouse output port connected to your computer, you can also use
the projector's remote control to operate your computer's mouse
wireless. (See page E-25 to connect your computer to the mouse
output port.)
If you want to use your remote control with the cable, connect
one end of the cable to the jack on the remote control and the
other end to the Terminal Panel.
NOTE: If you are using a Macintosh computer, you can click
either the right or left button to activate the mouse.
1 Left Click Button
Use this button to enter your menu selection. It works the
same as the "Enter" button on the cabinet.
2 Laser Pointer
Beams a laser light when "Laser" button is pressed.
3 Infrared Transmitter
Direct the remote control toward the remote sensor on the
projector cabinet.
4 LED
Flashes when any button is pressed.
5 Power On And Off
If your main power switch is turned on, you can use this
button to turn your MultiSync MT830/1030 LCD Projector
on and off.
6 Video Button
Press to select an NTSC, PAL, SECAM or NTSC4.43 com-
patible video source from a VCR, DVD player, laser disc
player or document camera.
7 S-Video Button
Press to select an S-Video source from a VCR.
8 RGB 1 Button
Press to select a video source from a computer connected to
your RGB 1 port.
9 RGB 2 Button
Press to select a video source from a computer connected to
your RGB 2 port.
10 PC Card Button
Press to display a slide from the flash memory card inserted
in the PC card slot of your LCD projector. (You must first
install the optional MT Viewer board into your LCD projec-
tor.)
OFF ON
PC CARD
VIDEO
RGB 1
MENU
R-CLICK/CANCEL
LASER
SLIDE VOLUME
S-VIDEO
POINTER
MAGNIFY
PIC-MUTE FREEZE
RGB 2
+
–
+ –
+
–
+
–
FOCUS KEYSTONE ZOOM
+
–
+
–
+
–
POWER
1
3
2
4
5
10
6
7
8
9