NEC MT830 - Manual (Page 15)

E-14
INSTALLATION 2
This section describes how to set up your MultiSync MT830/
1030 LCD projector and how to connect video and audio
sources.
Setting Up Your MultiSync MT830/
1030 LCD Projector
Your MultiSync MT830/1030 LCD Projector is simple to set up
and use. But before you get started, you must first:
1. Determine the image size
2. Set up a screen or select a non-glossy white wall onto which
you can project your image.
Carrying The LCD Projector Always carry your LCD projec-
tor by the handle. Ensure that the power cord and any other
cables connecting to video sources are disconnected before
moving the projector. When moving the projector or when it is
not in use, cover the lens with the lens cap.
Selecting A Location The further your LCD projector is from
the screen or wall, the larger the image. The minimum size the
image can be is approximately 0.5 m (20") measured diago-
nally when the projector is roughly 1.0 m from the wall or
screen. The largest the image can be is 7.6 m (300") when the
projector is about 12.2 m from the wall or screen.
Projection Distance and Image Size
Width
Height
Screen size
(diagonal)
Projection distance
Rivet
String
Lens cap
Attaching the lens cap to the lens hood
with the supplied string and rivet.
Throw Distance
Diagonal Screen Size (inch)
350
300
250
200
150
100
50
0
0.0 6.56 13.12 19.69 26.25 32.81 40.03 ft.
(2.0) (4.0) (6.0) (8.0) (10.0) (12.2) (m)
300”
235”
WIDE
TELE
27”
20”