NEC NP-P350X - Manual (Page 150)

132
6. Installation and Connections
COMPUTER 1 IN AUDIO IN
HDMI IN
USB(PC)
Computer cable (VGA) (supplied)
To mini D-Sub 15-pin connector on the
projector. It is recommended that you use a
commercially available distribution amplifier
if connecting a signal cable longer than the
cable supplied.
A commercially available
USB cable
(compatible with USB 2.0
specifications)
NOTE: For Macintosh, use a commercially avail-
able pin adapter (not supplied) to connect to
your Mac’s video port.
Stereo mini-plug
audio cable (not
supplied)
 Making Connections
NOTE: When using with a notebook PC, be sure to connect the projector and notebook PC while the projector is in standby mode
and before turning on the power to the notebook PC.
In most cases the output signal from the notebook PC is not turned on unless connected to the projector before being powered up.
* If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver or power manage-
ment software.
Enabling the computer’s external display
Displaying an image on the notebook PC’s screen does not necessarily mean it outputs a signal to the projector.
When using a PC compatible laptop, a combination of function keys will enable/disable the external display.
Usually, the combination of the “Fn” key along with one of the 12 function keys gets the external display to come on
or off. For example, NEC laptops use Fn + F3, while Dell laptops use Fn + F8 key combinations to toggle through
external display selections.
Connecting Your Computer
NOTE: Signals supported by Plug & Play (DDC2)
INPUT
COMPUTER 1 IN COMPUTER 2 IN HDMI
analog analog digital
Yes Yes Yes
HDMI cable (not supplied)
Use High Speed HDMI
®
Cable.
NOTE:
• When [VIEWER], [NETWORK], or [USB DISPLAY] is selected for [SOURCE], sound from the COMPUTER 2 AUDIO IN mini jack
will be output through the speaker.