6) correcting keystone distortion manually, Adjusting with buttons on the cabinet, Correcting keystone distortion manually – NEC NP-P350X User Manual
Page 40
22
2. Projecting an Image (Basic Operation)
Correcting Keystone Distortion Manually
If the screen is tilted vertically, keystone distortion becomes large. To correct keystone distortion manually, proceed
with the following steps to correct keystone distortion.
NOTE:
• The maximum range of vertical keystone correction is +/−30 degrees.
• The Keystone correction can cause an image to be slightly blurred because the correction is made electronically.
• The Keystone correction range can be made narrower, depending on a signal or its aspect ratio selection.
Adjusting with buttons on the cabinet
1. Press the
or button with no menus displayed.
The keystone bar will be displayed.
2. Use the
or to correct the keystone distortion.
3. Press the ENTER button.
The keystone bar will be closed.
NOTE:
• When the menu is displayed, the above operation is not available. When the menu is displayed, press the MENU button to close
the menu and start the Keystone correction.
From the menu, select [SETUP]
→ [GENERAL] → [KEYSTONE]. The changes can be saved with [KEYSTONE SAVE]. (→ page
• Keystone control is not available with the
or button when VIEWER or NETWORK is used.