Nokia 12 GSM MODULE REMOTE I/O - Manual (Page 39)

Table 9. Output_Get X commands
Command Type Command Comments
Output_Get All term123 Output_Get All
Response:
OUTPUT_GET ALL: OK
OUTPUT 1: Y
OUTPUT 2: Y
OUTPUT 3: Y
OUTPUT 4: Y
OUTPUT 5: Y
OUTPUT 6: Y
OUTPUT 7: Y
OUTPUT 8: Y
OUTPUT 9: Y
The Y refers to either ON or OFF
The command reads all
outputs and the response
returns the state of them
Output_Get X term123 Output_Get X
Response:
OUTPUT_GET X: OK
OUTPUT X: Y
The X refers to output pin number, X=1,2,3,4,5,6,7,8,9.
The Y refers to either ON or OFF
The command reads
output pin X and the
response returns the
state of it
9.3.5 Writing Outputs
Use the Output_Set X commands to set digital output states. Note that all
example control messages in this chapter use the “term123” identifier string and
the password property is set off (see Table 10).
35/49