Nlynx MinIT6000 - Manual (Page 59)

Network
The Network Setting Dialog Box lets you ether to enable a DHCP addressing or to specify an IP
address.
Network Properties Window
Obtain an Address from a DHCP Server
Click on this radio button to enable DHCP so you can obtain an IP address automatically
from a DHCP (Dynamic Host Configuration Protocol) server. This allows the network to
configure the TCP/IP information for your device.
Specify an IP Address
Click on this radio button to enable the following three fields for manually setting the
TCP/IP information for your device.
IP Address
Enter a static IP address in this field. It defines the IP address of the terminal, which
uniquely identifies it on a TCP/IP network
Subnet Mask
Enter the subnet mask of the IP address. This determines which part of the address
denotes the network.
Gateway
Enter in the IP address of the Gateway. If a host session address is outside of the Subnet
of the terminal, the Gateway address defines which gateway is used to reach the host.
Client IP Address
Click on the Client IP Address check button to show the Client information, including
Client name, IP address, subnet mask, gateway, DHCP server, DNS and WINS.